Answer Posted / guna
The resistance offered by a magnetic circuit or a magnetic
path is called reluctance
Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
State the points to be considered for selecting a particular type wiring.
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
what r the checklist while installing 500 kva transformer
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What information we need to prepare relay coordination chart
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
checking procedure of capacitor based motors.used in fans etc?
why impudance relay used for medium transmission power system? why not others?
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
What do you understand by oldham's coupling ?