Interested to Buy Any Domain ? << Click Here >> for more details...
Why all voltage level are multiples of 11, like 220V, 440V,
1100V instead of 200V, 400V, 1000V?
- 9 Answers
- 20849 Views
- Indian School of Mines, I also Faced
- E-Mail Answers
Answer Posted / mohamed
We are designed the alternators windings should be wound '11o' clock position.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
What are the advantages and disadvantages of closed-loop control system?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
Define active filter?
can u describe the method used for protection of transmission line.
how we find transformer capacity by ohm
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
Can anyone tell the proper diagram of star delta starter????
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
wat is the first thing dat is needed, 2 lay a cable in some area??
What are the advantages of the three-phase motor over single phase motor?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
