Answer Posted / manish gupta
I think that correct answer is that ohms law applies to single circuit but in transformer two circuits are electrically neutral so ohms law cannot be applied to two circuits simultaneously.it obeys ohms law separately for primary and secondary windings
Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
How to know the Max. current caring capacity of the cable by its size ?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
What is transister define the transister ammiter ,base, colector.
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is the ground fault relay,which purpose it will be use,clearly tell me plz
What is the difference between cylindrical-type and sandwich-type winding?
How the annunciator works ? How to do its wiring
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
how to test the electrical panel.ht lt mcc pcc.
what is the internal working of star delta starter
Why are iron cores in transformers made laminated?
At full load wat is the motor p.f And at no load will is the motor p.f?
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
If there is major % of Voltage harmonics in the system, how can it be control or reduced?