Interested to Buy Any Domain ? << Click Here >> for more details...
how to calibrate the temprature transmitter MURCREYtype and thermocouple input type.
- 1 Answers
- 4440 Views
- Shree Cement, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
I assume "MURCREY" is mercury, the chemical with the symbol Hg.
On-Off temperature thermostat controllers have used a
mercury filled switch for control output.
Mercury filled thermometers have been around for centuries.
But I am unaware of a temperature transmitter filled with
mercury. 2 wire, loop powered industrial temperature
transmitters with a thermocouple input have been available
for decades.
Configuration of the temperature scale corresponding to the
4-20mA output range and sensor type depends on the make and
model of the temperature transmitter. Different methods are
configuration
- with a HART communicator
- with pushbuttons and a local display
- with a software program and serial communications cable
and modem (RS-232 or USB)
- factory configuration
Calibration generally consists of trimming the 4.0 and
20.0mA levels by the same means as configuration, above.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
key exchanges in wpa,wpa2,tls
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Definition of reverse and acting controllers:
What is the purpose of the analyzer in petrochemical plant?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
ORP sensor working principle?
how works encoder in plc
Operational amplifiers
what is difference between HOT permit and cold permit
what is maxdna ?. explain about the software details.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
give me all the details about the interview and which type of question being asked
i need some objective type questions in instrumentation
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
what is performance test.need defination
