circuit breaker work alone during fault condition or need
any relays ?
Answer Posted / avd
It depends on circuit breaker. If sensing eliment is
installed inside the CB or outside the CB. Like MCCB with
maganetic trip latch will operate. Same way MCB will also
operate as it has short ckt and O/L sensing eliment. But
large circuit breakers have relays outside.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why do we use center tap transformer that used with portable tools
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
what is Different between Bilinear and Unilenier?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
what r the safety measures in UPS ? explain all?
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
What is the phase relationship between the primary and secondary voltages of a transformer?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
Define corner frequency?
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
How wire size can define in electrical wiring? What is the ratio?