Interested to Buy Any Domain ? << Click Here >> for more details...
What is main difference between
earthing and neutral grounding?
- 3 Answers
- 7320 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / sathiyamoorthy
earthing is used to fault conditions over current and
electrical equipment leakage current bypass to ground to
protect equipment this is earthing .
Neural grounding is used for star connection unbalance
condition time to balance the load and to reduce
harmonics
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what the function breaker failure scheme, how is it operated
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
full form of electrical?
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
What is conventional thermal current (Ith)
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
how to calculate transformer load?
Is there any guideline say about display of earthing value near to earth pit
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
How much dc volt applied in cathodic protection system?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
