WHAT IS THE LOWER LIMIT & UPPER LIMIT WHEN DIMENSION IS 9.0-
0.042-0.027
Answer Posted / duripandi
Ans is +/- 0.0345 and the nominal is 8.9655
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
if we not carried out B check at mean time in DG set what will be happen?
Re: what is different between run out and concentricity in Gd &T
alignment formulae for any two shafts for shim correction
what is the difference between set up of cast iron manufacturing industry and steel manufacturing industry?
Which pipes are used for steam lines?
For conduction of heat, the instantaneous rate of heat flow is product of three factors. What are these ?
Hello i want to design a portable 1/4HP pressure washer pump like elgi reciprocating pump which are being used in service station.what are the design aspects to taken in to consideration for making new pump.
Explain the difference between ferrite, austenite and graphite ?
water balance calculation for 1X500 tpd DRI plant?
what shows avribiations related to bearing blocks
What is the melting temperature of the cng long tube fusible plug? And can I use lead solder Sn97Cu3 (Melting temp S/L 227-309 °C) Materials of tube : AISI 4130 Alloy steel
Why pistons are usually dished at top ?
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
How the thickness of thermal boundary layer and thickness of hydrodynamic boundary layer related ?
Why would you use pneumatics?