Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / arunkumar
M30 GRADE OF CONCRETE DESIGN MIX .PROJCT CONSULTANTS REFER RATIO 1:1:2
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the difference between the concrete mix design carried out by IS10262 and by ACI method ?
Explain creep?
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
acceptance criteria for concrete works
sir, whitch is the best book (writer name) for prepration of gate....
How much river sand contain the 6 & 10 wheeler truck? Or Maximum sand that any type of truck carry?
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
what are RIB slabs explain about it
rate analysis hiring of generator 62.5 KVA
Draw the cross section of a boundary wall and label its part with detailing?
Is it possible to make a feature using an overdefined sketch?
how many litres of enamel paint required for 5000 sft of site??
whats is difference between anchorage length and development length
What is the difference between one-way slab and two-way slab?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
