Interested to Buy Any Domain ? << Click Here >> for more details...
How to convert gpm into inches of eater.I nerd formula with example so
pls help me.
- 1 Answers
- 4314 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
The pressure differential (h) [inches of water column]
developed by a differential pressure flow element is
measured, and the volumetric flow rate (Q) [gpm] can be
calculated using the following generalized formula:
Q = kA(h/D)^0.5
k is the discharge coefficient of the element (which also
reflects the units of measurement), A is the cross-sectional
area of the pipe's opening, and D is the density of the
flowing fluid. The discharge coefficient k is influenced by
the Reynolds number (see Figure 1-5) and by the "beta
ratio," the ratio between the bore diameter of the flow
restriction and the inside diameter of the pipe.
Nothing can be determined from only 2 data, volume in gpm
and DP in inches w.c. There is insufficient data and
probably insufficient attention in the classroom to think
that one converts to the other.
Carl Ellis
Measure First
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
all questions related to instrument technician in any offshore oil and gas company.
what is the procedure of O2 sensor(ABB) calibration?
how to calibrate load cell
line up procedure for dp type flow transmitter?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
TECHNICAL/ARTITUDE
What is the minimum rating availalbe for weld neck orifice in market?
Valve positioner and actuators in detail.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
What is instrumentation control?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
define feed forward control loop with example and drawing?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
