Difference between ultrasonic flow meter and radar type flow
meter
Answer Posted / carl_ellis
Difference between ultrasonic flow meter and radar type flow
meter
That's easy. Radar (radio frequency) energy is not widely
used, if at all, in commercial industrial flow meters.
Commercial ultrasonic flow meters use acoustic energy above
the range of human hearing to measure flow velocity of
liquids and gases. The measurement is inherently a
velocity measurement.
Transit time technology for liquids with no suspended solids
or bubbles, or doppler technology can be used for liquids
with suspended solids or bubbles. In-Line transit time
ultrasonic is accurate enough to be used for custody
transfer. Doppler has limited accuracy.
Carl Ellis
Measure First
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
How the warning lamp of a charging-system is activated ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
What is the purpose of bypass valve across AS valve.
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
How is work 5/2 sov?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
Why even multiple power supplu r used in instrumentation system?
Explain the working of an enraf level gauge.
What are the application of bernoulli’s theorem?
principle of dead weight tester ?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Please asked me How calculate DCS controller memory.
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
How to convert milliampares into flow??