Answer Posted / parijaat
power load means the highest power that a plant can use,and
lighting load means the minimum power to maintain emergency
process running in a minimum load.Suppose a steel plant
requires 20 mw power to operate completely,then 17/18 mva
power is its power load,and 2-3mva load to operate emergency
processes in running condition,so it is its lighting load.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
Why we use ups battery and dsdb battery in thermal power plant
what is invertor supply and raw powersupply
what is excitation/
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
Is there chopping current in resistive circuit
What is the use of oil in transformers?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
what are the different methods for the starting of a synchronous motor.
How to check the Bushings of the transformer?
How to Decide(calculate) Bush bar size for copper and aluminiam ?