Interested to Buy Any Domain ? << Click Here >> for more details...
what is tertiary winding in transformer?What is its purpose?
- 18 Answers
- 105975 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / adeel qaiser, engineering univ
>ìt provides a voltage level, that can be used inside the
grid station system to do drive domestic load.
>it reduces the fault current if connected in delta.
>it also distribute the fault current through its windings.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
Explain about p.t?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
Why efficiency in thermal power plant is low?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what is the function of impulse relay
What is resistance reading of earth copper rod with grid and without grid?
How many types oil using in transformer ? How many letars using in transformer..?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
How does a television work?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What is the significance of integral controller and derivative controller in a pid controller?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
