what will happen when excitation of a synchronous machine
is suddenly reduce to zero when it is running at full
load..??
Answer Posted / jamshed hussain (from quest)
In synchronous generator the excitation is given to the rotor circuit and magnetic field is produced. If the excitation is reduced to zero then there will be no magnetic field. It means that no excitation, no magnetic field, so there will be no generation.
Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
What are n circles?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
We have given to 3phase supply to ups system & how can coming netural
1.4 What is meant by CT knee point voltage and how would you determine it
What are the advantages of vscf wind electrical system?
What is the difference between resistance grounding system and resistance earthing system?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What is the difference between line drop and percentage line drop?
How to Prepare preventive maintenance shedule of machine tool.
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams