I want Primary side delta and Sec side Star connection
transformer . but i have received Star - Star
transformer ,shall i use the same transformer by giving the
only 3 ph on Primary side without Neutral connection on the
Starpoint.
Answer Posted / vinod
Main reason to use Delta in primary side is to reduce/Eliminate harmonics in primary side whereas star winding will not eliminate.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why and where we use early make & late break contacts in protection?
What is a feedback in control system?
Why does the rotor rotate?
how to design the heater in temperature control unit to heat 50KL of water?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
what is electrical machines
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
Power Factor Correction Panel (Manual & Automatic)
What is step signal?
I want to replace the 3 KW DC motor with AC motor so what should be the rating of AC motor? Details Of DC motor to be changed with AC are - Kw - 3, Vf - 310, If - 0.15, Va - 400, Ia - 13, RPM - 2400
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
Define resonant peak?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
whate is the meaning of balance/unbalance,in stabilizers type