Interested to Buy Any Domain ? << Click Here >> for more details...
what is closing resistor in circuit breaker? why it used?
- 3 Answers
- 17626 Views
- I also Faced
- E-Mail Answers
Answer Posted / william wright
Closing resistors are also intended to allow shunting of
over-voltages power surges that cause that can damamge the
system protected.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
There are different classes of protections in power plants.class a,b,c are clear..is there any class d and e r there..and elaborate class b protection.
how to build a network which step down 415v to 1v rms
What is the difference between indoor and outdoor transformer
Why control of DC motor is simpler?
What is gain margin?
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
how a flip flop can be used as a latch?
What is the permissable nutral current of three phase system as per IS standards?
12.5 tons a/c is their how much kva generator can recommend to the customer.
Why the cores of large transformers build up of circular cross section?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is different between Difnit time and instatous over current relay
how tto ingress mw in turbine explain.procedure ?
what is ground fault in ACB?
