Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / fazul
In a.c system current and voltage are lag or lead according
to the inductance or capacitance.
but in d.c system current and voltages are inphase with each
other.so phase angle between current and voltage is zero.
we know p.f=cosO
p.f=1
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the difference between droop mode and ischnorous mode in thermal powerplant?
What are the two types of compensation?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
How capacitor improves pf
please send previous exams question papers
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
What is the distance between each insulator in 33kv transformer and how can it calculate
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
State the points to be considered for selecting a particular type wiring.
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
How grounding is different than earthings?
How does an induction motor start?
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
