Answer Posted / fazul
voltage is constant for dc supply.
hence current is also constant for dc supply.
hence the frequency of dc supply is zero.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
sugest any typical project ?
What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
300m long and 30kw inductive loade 3phase supply how many size cable required
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
What are the different methodes for calculating the short circuit Current?
Why the symbol of register is "zig zag"
When will you multiply and devide with derating factors to the actual value while sizing the cable?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
which network topology offers the greatest level of tolerance?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
