Interested to Buy Any Domain ? << Click Here >> for more details...
i want to control the temp of sand(welding flux) between the
range of 150deg C to 170deg C. sugges me sum temp control
method without PID controller.
- 1 Answers
- 3379 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
An On-off controller with a setpoint of 160 Deg C and a
hysteresis of ±10 Deg C will do this type of control.
Carl Ellis
Measure First
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
pls give me presant awerness quistion and answer in my emailid.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
How will you calibrate PID controller? explain with example.
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
all types of liquid analyzer principle with drawing?
Explain about the leakage class of the control valves
what is SIL 1 2 3
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
NSV type probe stands for
what is the difference between active & reactive power?
how the arrangement of equipments done in control room
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
