Why we connect the capacitor in Delta?if we conect in Star
what will happen?
- 9 Answers
- 30068 Views
- I also Faced
- E-Mail Answers
Answer Posted / pravin m sonwane
in medium voltage Delta connection or star ungrounded is
mostly used because of
1)Harmonic current is circulated in delta loop, hence no
damage to system
2)Across capacitors phase voltage is present.
3)more efficient configuration than other like star, star
grounded, star ungrounded, double star neutral may or may
not be isolated, double star with neutral grounded.
4)No zero sequence or third harmonic currents can flow in a
star-connected capacitor bank. Additionally, where one
series group per phase is used, the individual capacitor
fuses should be capable of interrupting the system
short-circuit phase-to-phase fault current.
5)The greatest use of A-connected banks is at 2400 V, since
this is the lowest standard capacitor voltage rating.
6)As zero sequence or third harmonic is absent, less
protection to bank is required. hence less costing in such
capacitor configuration.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the safety of voltage power transformer(2250KVA0
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
What are the different types of dams?
tell me about roaster switch .& what is the function in transmission & distribution?
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
1 Ton is equal to how many watts?
Differentiate between voltage and current feedback in amplifiers?
why using transformer and thyristor switch in 3 phase apfc panel
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Fantio of tranformer
Difference between on line capacitor and Station type capacitor
What are PLC leader logic program method
what is method for testing CT
