Interested to Buy Any Domain ? << Click Here >> for more details...
how much fuel is consumed on full load for a 500KVA Diesel
Generator in one hour.
- 5 Answers
- 13526 Views
- I also Faced
- E-Mail Answers
Answer Posted / ed onmata emmanuel
At full load a 500kva diesel engine consumes approximately
100L/H. This, however, depends on the quality of the fuel
(diesel.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
if we not carried out B check at mean time in DG set what will be happen?
What will happen if head of a selected pump is not utilized in a closed loop water circuit? Flow will increase or decrease or remain same?
for under water excavation works, can i have some standard codes and specifications(international)
When a 30KW/3 ph pump runs one hour continously, what will be the heat dissipated? how can i find this, any general equation?
Where id the warm side of a refrigeration system?
WHAT ARE EARTH MOVING M/CS? WHAT IS BATCHING PLANT? WHAT IS HYDRAULIC JUMP? WHAT IS TIPPER (EARTH MOVING M/C)?
can i apply for rrb with my provisional certificate..........
Is OHNS steel is equivalent to O1 tool steel? Suppliers give OHNS material for AISI O1 STEEL telling that both are equivalent materials. Is this correct?
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
state the law of thermodynamics?
How fuel oil consumed by medium engine?
What are the causes of damage of diesel engine exhaust Valve?
What is the use of rasp file?
Hello there, Im a Mechanical Engineer. I passed out in 2010 and have worked for 6 months in the Middle East as a Trainee Engineer. Im now in India and due to appear for an Interview for a firm in the Middle East. The post is of an Automobile Engineer. Im kinda nervous as to what to prepare for the interview. The training which I got was in different areas ranging from technical to managerial aspects. What I mean to say is that that was more of a crash training, where I couldn't stick to one section alone. The interview which Im attending is more of a technical one. What I would like to know, how and what I should be preparing? I have two weeks for the preparation. Should I go through the normal automobile aspects or everything in random. PS: I have excellent communication skills, the one area in which I'm very confident.
What is torsional???
