in an open circuit. test there is no
load curent..
but secondary. ia open then no
urrent have to flow
but there a smaller current flows
why?
- 4 Answers
- 5072 Views
- Rubber Park, I also Faced
- E-Mail Answers
Answer Posted / manoj kumar
It is due to the eddy current which
produces unwanted current.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
At what factor resistance r of a conductor depends?
single phase power supply give to separate one steel coup with water, what reaction create
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
how to decide choke rating for drive?
What is critical disruptive voltage?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
how does high earth to neutral voltage affects electronic circuit?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
How can we findout the maximum efficiancy of Transformer? At which load?
If we connect a motor and generator together (I mean that the generator gives the motor electricity and the motor gives the generator movement) regardless the losses. Will the generator still generate and the motor still move?
.php|
What is vaccum currcuit breaker.define with cause and where be use it device?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
