Interested to Buy Any Domain ? << Click Here >> for more details...
how to get 48 V DC
I have ...
1. 12 volt power supply board
2. DC power supply ( max. 30 v)
3. 9 volt batteries ( 2 - not
chargeble)
- 2 Answers
- 4626 Views
- I also Faced
- E-Mail Answers
Answer Posted / kailash
firt of all connect these batteries
in parallel if more current require
otherwise in series now use an
electronic circuit to convert it
into ac with a step up transformer
to get 48v that can be now converted
into dc again by rectifier circuit.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to Calculate KA Rating of Main LT Panel
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
What is VCB? where it is installed at SP. What is SP?
What is meant by reset level of the relay?
What are the transformer losses?
What is the difference between multimeter
how to calculate cable size in diffrent loads?
Why have to use copper cable for local isolator to motor ?
how power is generated,and transmitted to our home..pls explain briefly in simple words.
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
what are the applications of TIG welding
can i connect the two phases of scott connected transformer,if not why?
what is servo motor and how to work it.
