Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / khurshidmallick0786@gmail.com
Khurshidmallick0786@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
Where is wet leg is used?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
How many interlocks at turbine? Plz explain briefly
how to relay switch sense the fault?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
What is sensitivity in vibration probes..?
Explain types of valves?
What is the procedure of calibration of Load cell?
any body please send me the old question papers of ongc test.
if my flow is 20000 m3/h than which range of DPT i have to use????
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
