Interested to Buy Any Domain ? << Click Here >> for more details...
while stroke checking of a linear control valve ,found its travel is in non linear ,what can be possible reason ? ( please answer send in mannanali65@gmail.com) pls pls pls if any body know
- 2 Answers
- 6442 Views
- JAL International, I also Faced
- E-Mail Answers
Answer Posted / md altaf
If your ccontrol value was nonlinear 1st you check the strock was set same(set back side of your positioner) as your control(wrriten on your control valve body).
2 and step was after equalise the stock then you adjust span and zero.
After you set the span and zero the control valve was working in normal condition.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calibrate H2s Dectector
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
any questions on motor and energy conversions machines?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
Explain bernoulli’s theorem. State its application.
Coal mill Instruments Equipments for cement plant And process diagram ?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
wich is coming the first HAZOP OR SIL
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Calibration of controller (pneumatic)
for oil & gas industries which zone is normally preferred? why? give its example?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
