Interested to Buy Any Domain ? << Click Here >> for more details...
Ammeter of 1 ohm resistance measure max 10 ohm to measure
higher resistance from it
- 6 Answers
- 7937 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / er. sanjana singh
ammeter measures current not resistances!!!!!!!!!
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
Why single phase induction motors are not self starting ?
how many current required for hypo test
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
what is mean by descripiency relay? & wht is its ansi code?
Why to keep capacitor bank off while generator running.
how do you test tachos and servos
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What is the formula to calculate the no load current of a single & three phase induction motor
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Load break swicth maintenance procedure.
