Interested to Buy Any Domain ? << Click Here >> for more details...
You are given 220 V supply source, four wires, an ammeter
and voltmeter. There is no any indication or description on
meters. How will you identify which is ammeter or voltmeter?
- 7 Answers
- 10928 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / ashok mishra sddiet
connect both in series with the source as amitter having low resistance will show high reading and voltmetre having high resistance will show low or almost zero
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I am going to appear RRB Sr. Section Engineer Exam, Electrical. Can you send me previous year questions of RRB Electrical engineer. specially Section Engineer questions. my email id is likerahulworld@gmail.com
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
Pl. share your experience about industrial-electronics repair of machine tool.
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
When and where resistance earthing is used ? How to calculate the time constant for earth fault
difference between high and low impedance BUS BAR relay??
what is the write prosidure of stringing of 8meter pcc pole.
What is the purpose of stand by earth fault protection for transformer ?
what are types of encoder
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
what is the terminal voltage of dc series generator running at rated speed at no load?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
