Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference b/w the solinoid volve and autodrain?
- 3 Answers
- 6986 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhirendra
both are same
drain valve will be oprate solenoid
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Name different parts of a pressure gauge.
What is 3 selection available when configure the burnout protection for controller
What are different types of orifice plates?
how to commission furnace ( water heater)
Why are the uses 24vdc in industries
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
TEMPERATURE VARIATION FOR FREQUENTLY.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is compensation? temprature & pressure
How to calibration coriolis flow meter?
What is the procedure of calibration of Load cell?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
What is 3 element control system
