Interested to Buy Any Domain ? << Click Here >> for more details...
why the conservater tank alwes made upper side of
transformer???
- 3 Answers
- 5271 Views
- I also Faced
- E-Mail Answers
Answer Posted / parag nikumbh
Conservator tank always mounted on top for being reason during Load on transformer Oil expands in volume so excess oil will go to tank and during no load or under-load oil contracts so due to gravity it should fill up the gap in main tank,this is possible only in case if tank is mounted on top or otherwise a means is to be provided to recirculate oil to main tank which is not economical in case of smaller sized transformer.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
What is mathematical model of a control system?
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
Define noise?
What happen Grid EARTH plat got cut.
Initially, when the input is not equal to the output — what type of response is this?
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
What is difference between Over Current & Earth Fault protection?
Under wat condition statcom operates as an inductor for the transmission line?
what clearance required for 4.5 mva dry type transformer?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
what is excitation/
