i am trying to select the correct grade steel for a shaft
that will have a flap on it weighing about 4.5 tons being
forced up with hydraulic rams. can someone tell me what
grade the shaft should be and if it should be stainless
steel or not
- 2 Answers
- 3430 Views
- Rainford EMC Systems, I also Faced
- E-Mail Answers
Answer Posted / sahil salota
yes it should we stainless, because the corrossion is
decreas the life of the steel or strenth.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Which types of questions ask in pool campus pune in technical and aptitude test
Explain the nuclear reactor.
where we can get the surfacing modelling project of example to practice in catia.
how to calculate air load of a existing/ new plant before installing a air compressor.
What is the cause of pressure drop in a centrifugal
SIR I M STUDENT OF POWER ENGG CAN I GIV PSU XAM 4 NTPC AND WHAT WOULD B THE PROCEDURE
What will you do when scavenge fire happened?
Why axial flow compressor is preferred for gas turbines for aeroplanes ?
Dear all i have applied for section engineer post in RRB Chennai can anyone please send previous question papers please do it if u have
Discuss venturimeter?
What is the formula to determine the speed of induction motor?
Define steam turbine diaphragm?
What are the causes of dirty lubricating oil?
What is the purpose of starting air?
If mft not act when spark failure 3 time what problem will happen in boiler side
