WHAT IS THE ROLE OF ELECTRICAL & ELECTRONICS ENGINEER IN
TCS.
Answer Posted / rakesh kumar
single lay diagram, electrical equipment specification, etc...
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
along with technical test papers
What is the difference between a 3 winding and 2 winding Potential Transformer
What is “pu” in electrical engineering?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
DC transmission
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
how does high earth to neutral voltage affect electronic equipment?
What is power factor why we should maintain the power factor unless what will happen
What is a slack bus?
can i use ups power as a raw power for another ups
Which power will flow first if we switch on a motor Active or Reactive? How?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?