Answer Posted / dilip jha
T=mv*25
Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
what is function of SCADA , and how is it work, explain with difination
what is interlock system and why we use of this?
how do calibrate the valves.. with clear manual
Explain Gas Turbine startup and shutdown sequences
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is the input of digital counter during the the calibration time?
this site is owned by an nonsense
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is the protection system in solar turbine compressor
why is not useing in boiler skin thermocople
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
TECHNICAL/ARTITUDE
how to convert cubic metre per hour to newton cubic metre per hour
Explain the working of rota meter.