Answer Posted / rohit saroha
NGR(Neutral Ground Resistor) which is connected at the star point of an
alternator ... N.G.R PROTECT TO ALTERNATOR WE ARE USE C.T. IN N.G.R.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
what is the use of piston rings in the engine used for a generator...........
can i use 2000/5A Clamp meter to measure HT cable
Explain the working principle of Synchronous Generator and Assynchronous generator?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
What is the basic principle of operation of alternators/dc generators?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Why colled 440V to 3-phase supply.
What is the test block protection relay if any body know plz explained
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
how the aircraft outer body and inner body is separated ?
