Interested to Buy Any Domain ? << Click Here >> for more details...
what is the significance of pressure angle in spur gear?
What is meant by self locking in worm and worm gear?
- 11 Answers
- 50470 Views
- I also Faced
- E-Mail Answers
Answer Posted / roma singh
It is the angle at which the drive force is greatest i.e the point at which the maximum power can be transmitted by driver to driven gear. pressure angle must be an optimum value , lower the pressure angle leads to increase the stress concentration factor make gear of low strength e.g older gears(14.5). Now a days 20 pressure angle is used as it transmit large torque and power . it is generally use in aircrafts .
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
Fabrication Defects
solar cooker based on the principle
Name the carpentry process?
What is the materials of cotter joints?
what is the minimum velocity of cooling water for maximum efficiency of condensor.
What is the maximum P-max for a cylinder in M/E.
How cavitation can be eliminated in a pump?
Explain what are the thermal conductivity properties of brass?
What are bevel gears and what are its types?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
I am a mechanical student.And have cleared the written for NTPC. Please suggest what and how to prepare for the interview.i have got only 2-3 weeks in hand.
what is the three phase induction motor? what is difference between motor used in household instruments and induction motor?
What are the causes of dirty lubricating oil?
Can metal vapour converted to solid metal
What happen when too much cylinder oil is injected in the working cylinder?
