Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinesh
% impedance indicate the potential to decrease the fault
level in system by that eqipment. % impedance values msotly
occur in between 2 to 20 %
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
11 kV line deraction check by an Engineer.
What is servo motor? what is its purpose?
Can we use shunt trip coil instead of trip coil with protection relay for protection?
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
What is acsr cable and where we use it?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
explain wiring system
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
what type of earthing do for dry fissure rock?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
what purpose to use excaiter in DG.?
How much load can be taken for chiller from 1500 kva transformer
