Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / carl_ellis
A Load line shows the valve's pressure drop at different
flow rates. When graphed, the flow rate is typically on the
y axis, the pressure drop on the x axis.
Typically the load line starts high at low flow (high DP)
and decreases as the flow increases to a low DP when the
valve is wide open.
Carl Ellis
Measure First
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is rang ability?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
How oil line flow measured?eplain about instruments used and working principle?
what is the calibration procedure for transweigh make weigh feeder?
What is Erosion in a control valve?
what is zero and span ?
Why flow/pressure transmitter before control valve?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
what about your moleg in pogrees with company
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
