why field winding is placed on rotor winding not on stator
winding in case of synchronous machine?
Answer Posted / mukesh
if field winding is mounted on the stator then 4 slip rings
are required,hence bulkness and cost will increased and due
to large current flow more insulators are required(for
avoid heating) as well as rotor inertia is also
effected...while if we placed field winding on rotor then
only 2 slip rings are required hence the problems due to
opposite winding can be avoided.
Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
A low wet bulb temperature indicates
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
Why derivative controller is not used in control systems?
In how we connect watt meter for open & short circuit test of a single phase transformer.
What is meant by stator? What is meant by rotor?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
What is an Air COmpressor
What is meant by short-pitched winding?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
What's mean HVF & HAF in Vacuum Circuit Breaker?
How is the gain affected by the introduction of feedback in a control system.
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.