Interested to Buy Any Domain ? << Click Here >> for more details...
Hi,
I've just got into my electrical engineering course and I need some help with a question of mine here.
During a site visit, we were shown a main LT panel which has switchgears, ammeters and different kinds of relays and the distribution network from that panel. In the main LT panel I've noted down the current readings as Ir - 163A, Iy - 150A and Ib - 147A. The Line to Line voltage is 415 V at 50 Hz and Line to Neutral voltage is 230V at 50 Hz.
From the above details, how would I calculate the kVA rating of transformer? The primary side voltage of the transformer is 11 kV and the secondary side voltage is 415V and the frequency is 50 Hz.
- 2 Answers
- 3969 Views
- I also Faced
- E-Mail Answers
Answer Posted / 7anoter4
Something is not correct. If VL_L=415 V then VL_N=240 V
[not 230 V] and then
both calculation results will be the same [no error].
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the role of feedback in a closed loop control system?
IN 1000kva transformer where the oil and winding temperature sensors is connected
Show Details FROM:Muhammed Ikram TO:qa@allinterview.com Message flagged Saturday, June 4, 2011 10:07 PMMessage bodyHello all, i want to ask a question to all of you that what is VMM (voltage monitoring module )? how it work,s? i heard somewhere that it compare 1 phase voltage to other phase voltage. but there is also some setting on it. how to set it,s setting. please tell me briefly. Thank,s and Regard,s. Muhammed Ikram.
Tell me in detail about c.t. And p.t. ?
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
how technical is calculated in 11kv line and lt line
What is the approximate value of stacking factor?
i have interview in Pepsi company what type of question will ask please send the question and answeer
What are the conditions to be satisfied for parallel operation of dc generators?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
what may the reason for vector shift in a generator?
What are dcs and plc?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
How one can check the MAIN of a house wiring ?
