Is it possible to connect a dYN1 transformer in
parallel with a YNd11 transformer.
- 4 Answers
- 14161 Views
- I also Faced
- E-Mail Answers
Answer Posted / raul
Yes, it is possible to parallel the YD11 AND DY1. Because
they lie in the same phase difference group family of the
paralleld connections. Since the phase angle difference
between the primary and secondary in both the cases is 30
degree lead and lag.
The possible parallel connections are :
1) YD1 AND DY11
2) YD11 AND DY1
3) DD0 AND DD6
4) YY1 AND YY11
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
why are u join ntpc
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what is the working principle of energy saver control panel. please give the complete calculation & theory.
For a stable system, where should the poles of a system be in a root loci plot?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
Define bibo stability.
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
State kirchoff voltage law?
how to decide the panel size like MDB ,SMDB PANEL SIZES
slipring induction motor starting time Lrs operating why lrs starting time lrs outer body didn't get shock
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
How is the percentage impedence of a transformer fixed at design stage???
What is mean by STUB protection?
