Interested to Buy Any Domain ? << Click Here >> for more details...
IN 3 PHASE INDUCTION MOTORS SOMETIMES COPPER BARS ARE PLACED
DEEP IN ROTOR WHY..?
- 3 Answers
- 11804 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / raul
This design is known as Deep bar rotor, which is basically
a modified rotor design in Squirrel cage induction motor.
During starting, the rotor frequency (i.e. Fr = slip *
supply frequency) is very high and the rotor reactance
value is very high, due to which the rotor current is
restricted to the near slot rotor copper and the area of
cross section of the conducting rotor conductors reduces
and the net resistance is increased due to which the
starting torque and the slip at which the max. torque takes
place also increases. And as the rotor picks up speed, the
rotor frequency and hence rotor reactance starts decreasing
and the complete deep bars carries uniform current and
torque reached steady state torque.
Another design with the almost the same above principle is
the DOUBLE CAGE ROTOR
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
What are the parts in a inverter?
How to calculate ant test the burden of Current transformer
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
number of I/O devices in siemense plc
1.what is difference between ATS & STS main use. 2.what is difference between ACB& VCB With symobles,and main partes, manimum range. 3.How many types of relays and main function.
What are the advantages of vscf wind electrical system?
why industry prefer ht motor instead of lt motor.
is it possible to start a motor in felid connected to a remote mcc
can anybody sent me power grid questions. what subject should i prefer for preparation?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
