Interested to Buy Any Domain ? << Click Here >> for more details...
Where are use of pressure,level,flow switches?and what is input and
output
- 3 Answers
- 7443 Views
- I also Faced
- E-Mail Answers
Answer Posted / greenborhan
1. Pressure switch used on pressure line/process line (pipe) to save the line/process from over pressure.
2. Level switch used on Drum/tank/vessel to see the level of the drum/tank/vessel.
3. Flow switch used the line through which fluid/liquid/air/gas is flowing, it confirms that if there is any flowing elements or not.
Input of all these switches are +24VDC and output of these are Digital Signal, these switches send a Digital Signal/Input to DCS.
My answer is right or wrong?? I am a little bit confuse...
greenborhan@gmail.com
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to convert Differential pressure to flow in TPH
what is the process to make control schematic ?
what is the protection system in solar turbine compressor
How to erection of DCS Panel at site step by step
How flow can be measured with dp?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Explain the working of an enraf level gauge.
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
is motorized valve closed when power shutoff?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
