Why is transformer connect parallel? why
not series? ....plz...
Answer Posted / debasis paul
Transformer always done in parallel connection because when two or more transformer connected in parallel it is work depends up on the impedance. so that will not possible for series connection.
When two or more transformer are connected in parallel then increase load current but load voltage to same.
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the criteria for selection of conductor used for ehv ac electrical dischrge
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
how many stairs have you climbed while you were coming
define hysteresis loss, eddy current loss and windage loss
what is (+) and (-) in generator field detector stand for?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
can someone explain that how the speed of the protection system affects the fault level calculation?
How to check the LM324 Ic
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
Difference between Lugs and Thimbles
Explain what is electric traction?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
What is advantages of VSCF wind electrical system?
why high speed tripping relay will be used in tripping circuit why not normal relay
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds