Interested to Buy Any Domain ? << Click Here >> for more details...
What types of motors are used in cranes
- 9 Answers
- 43007 Views
- BPDB, BUBT, CNH, I also Faced
- E-Mail Answers
Answer Posted / milinda4p
Biki: AC slip ring motor?? I think you mean wound rotor
induction motor as it is the only AC motor which has slip rings?
Biswa: Normally squirrel cage rotors are made of two copper
rings connected by copper bars. So how to make it high
resistive?
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
working principles of cf lamp,incandescentlamp and f lamp?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
What is q factor?
List examples of voltage source?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
how to calculate short circuit current for the busbar
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
What are the different sign conventions used in electric circuits?
How is operate breaker failure scheme in substation
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
