why transformer ratings in kva?
Answer Posted / hitesh chauhan
because transformer not consumes the power.It take the power
from input and its given to output.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
What facility we get after CT secondary earthing and how?
what is Anti-pumping?
Why the power factor improvement is so important in industrial loads
what is difference between cpp electrical system and refinery electrical system
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
11 kv input, 66 kv input advantages
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......