can we use 220 volt 15 w a.c. lamp on 220 volt d.c.
- 6 Answers
- 7544 Views
- TCL, I also Faced
- E-Mail Answers
Answer Posted / barbara wild
hallo,i was just reading your question ...i am looking for a
lamp 220v 15 w and cant find them in germany could you let
me know where i can order them ? thanks barbara
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
how can maintaince the acb contactor moveing and fixing kit
If increased the frequency up to 1000 then what changes shows in voltage?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
wat is the first thing dat is needed, 2 lay a cable in some area??
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
How many types of protection relays are there based on the characteristic?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
Why collecting electrode of ESP to be earthed
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
Difference of induction motor & servo motor ??
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
