Answer Posted / afsar mumtaz
hi,
both are temperature measuring device ,
thermocouple is passive device and RTD is active device .
thermocouple generate milivolts and RTD generates resistance.
thermocouple are used for high temperature and RTD is used
to average temperature.
wire length is factor for RTD but in case of thermocouple no
mean.
thermocouple consist 2-3 wire but RTD 2-3-4 wire connection.
thermocouple range -260 to 2300 degree centigrade
RTD range -260 to 650 degree centigrade
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
Please can anybody help for control valve sizing step by step procedure?
What is 3 element control system
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
please send the drdo exam paper
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
How to measure the dust in chimney(spm)?
How servomotor controls throttle valve of TURBINE?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?