Answer Posted / ghulammohyhuddin
1 unit = 1kwh one 1000 watt hour
how mach kva use in three phase 440
2 kva will be required
Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
what is the difference between gas group b and gas group c electrical equipment construction wise?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What is the name of the winding to which supply is given?
explain the mode of metal iranafer in Co,welding
limitation of conductor height on ground when we consider EMC
How does zener phenomenon differ from avalanche breakdown?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Explain in brief description about the operation of DG sets.
when will be the iocl interview results ifaced the interview on september 8 th
What difference between ref protection and differential protection ?
Compare salient pole and cylindrical rotor machines.
What is the ideal position cooling fan inside the dc motor?