Answer Posted / durga charan giri
manganies steel
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
please send interview questions on foundry. my email id is m_vijaypanday@yahoo.co.in
What is the importance of tolerance in engineering?
Explain the difference between the points of inflexion and contraflexure?
Name the strongest and weakest type of atomic bonds?
i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.
What are steam turbine parts usually come into damage?
What is the formula for 1 HP of a two-cycle engine?
what will happen if petrol engine make to run with diesel
Which case we will find maximum pressure and flow in centrifugal pump - circular casing or volute casing ?
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
what shows avribiations related to bearing blocks
Where can you find space heater lam p and what is its purpose?
Where can you find the feed check valve and feed stop valve and give the purpose of it?
if any one who attended the caterpillar interview please send me the sample questions and the areas from which questions are being asked...
Crankcase oil mist detector