Interested to Buy Any Domain ? << Click Here >> for more details...
What is the lapping length for 32mm steel rod as per BS
standards?
- 4 Answers
- 17371 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh
IN M25 Concrete - 32 MM dia Steel bar Lap should be LD*32 Dia i.e. 32*49=1568MM
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
I need model question papers for writing the Dubai municipality exam,for G+1
How much quantity of cement Bag for block masonry (1:4) for 1 cu.m? Block size (150x200x400) Mortar Thickness 20mm
How many lbs are there in a yard?
I have a slab of 20cm thickness of 20m by 4m in wich we are installing 15 tons electric panels , and we have put 4 H-shaped columns under the slab but we have done many cores in the slab which seems very normal , can you help me by telling me how to calculate the bearing capacity of the slab or give me an idea if i should increase more columns Note: load distribution area 12*1.5 m2
List out some of the software program that can be useful for architect?
How much cement will require for 1Rmt Skirting laying
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
for G+2 residential building how much quantity of required in foundations,sub & superstructures per sq ft area
what is meaning of inverted beam.is it way to provide double mat in slab one at bottom and another at topif we go for provision of inverted beam. shall we construct structure with out plinth beam for us we have to construct small bus shelter
show answer/ calculate-1-2-4 ratio-concrete -cement-sand- metal-water - please brief calculation
how to calculate the strength of rebound hammer test reading in building construction ?
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
what pressure the NP2 class RCC pipe can sustain?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
in one hour , one 200 excavator , how much quantity (mcube)can load ? soil is not hard not soft
