IN THE CASE OF AN ELCB, IF THERE IS ANY UNSTABILITY BETWEEN
PHASE AND NEUTRAL IT MAY TRIP. BUT MY QUESTION IS WHEN A
LOAD IS CONNECTED IN BETWEEN P AND N, THE LOAD CONSUMES SOME
POWER AND THERE IS A DIFFERENCE IN NEUTRAL WITH RESPECT TO
THE PHASE. THUS ACCORDING TO ME, THE ELCB WILL AUTOMATICALLY
OPERATES WHEN EVER THE LOAD CONSUMES-- I KNOW IT IS WRONG.
BUT THE SOLUTION IS?????????
Answer Posted / pillay
Maybe your understading of the elcb/ rccb is not true.Any load
consumed current is shared among the phases or and
newtral.that means what ever current that flows through the
elcb must flow out,there can be a difference only when there
is a loss, which means some of this current that had flowed
through are flowing out a different route,(leakage)if this
difference exceeds the trashold of the elcb/rccb than it
trips.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
can you any one give exact mathematical relation between AC current and DC current?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
How many capacitors using in LT panel as per Govt rules?
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
what is doid
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
What cmos is and its benefits?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
What is called limb of a transformer?
what types of cable used in underground coal mining?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Approach of a cooling tower is the difference between temperatures of what factors?