Interested to Buy Any Domain ? << Click Here >> for more details...
Can anybody explain me the electrical circuit of indian
railways to drive electrical engines(LOCOMOTIVES)? How does
overhead lines work in the circuit to drive different
trains on the same track?
- 1 Answers
- 3198 Views
- I also Faced
- E-Mail Answers
Answer Posted / aditya shirbavikar
The circuit of an electric locomotive starts from the current
collector and ends at the railway track.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Load break swicth maintenance procedure.
I want to know all basics of electrical engineering
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
which type of amplifiers are used in multimete?
How many types of protection relays are there based on the characteristic?
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
How is the connection of the tap changer on the HV side been made?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
What is the relation between frequency and motor rpm?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
how to changeover ups in this power failur time?
